ASTM A600 PDFASTM A600 PDF

1 This specification is under the jurisdiction of ASTM Committee A01 on Steel, 2 For referenced ASTM standards, visit the ASTM website, , or. ASTM Aa(). Standard Specification for Tool Steel High Speed. standard by ASTM International, 03/01/ View all product details. Most Recent. ASTM A Standard Specification for High Speed Tool Steel.

Author: Kigashicage Gajinn
Country: Montserrat
Language: English (Spanish)
Genre: Education
Published (Last): 24 October 2004
Pages: 118
PDF File Size: 4.52 Mb
ePub File Size: 1.26 Mb
ISBN: 316-7-58865-868-3
Downloads: 50470
Price: Free* [*Free Regsitration Required]
Uploader: Garg

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Cold working may be accomplished with the alloy in the annealed condition. Then heat rapidly from F to F and hold for 3 to 5 minutes followed by quenching in oil, air or salt bath.

Modulus of Elasticity Tension. Do Not forge below F. Historical Version s – view previous versions of standard.

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Anneal at F and slow furnace cool at 40 F 6a00 hour, or less. See “Forging” and consult the supplier for information on working at lower temperatures.

  JOUKOWSKI TRANSFORMATION PDF

The M2 alloy has somewhat better wear resistance than M1. Hardens by heat treatment and quenching.

ASTM Aa-High Speed Steel – Special steel china supplier-OTAI Special Steel

A chemical analysis of each heat of steel shall be made to determine the percentage of the elements specified including carbon, manganese, phosphorus, asmt, silicon, chromium, vanadium, tungsten, molybdenum, and cobalt and these values shall conform to the requirements as to the prescribed chemical composition.

Preheat at F before heating for hardening. The maximum Brinell hardness and minimum Rockwell C hardness for the tool steels are given. M2 is classified as a “medium” machinability tool steel in the annealed condition.

S600 to Active This link will always route to the current Active version of the standard. Temper at F for a hardness of Rockwell C 60 to Formed by machining or forging and then machining. Consult the alloy supplier for information on the advisability of welding. Unless otherwise specified, material shall be made by an electric melting process.

Selection will depend upon design, service conditions, and mechanical properties. Two intermediate high speed tool steels designated as M50 and M52 are also covered.

  GHOST TOWN ROBERT COOVER PDF

ASTM A600 T5 High Speed Tool Steel Round Bar

Forge at F down to F. This abstract is a brief summary of the referenced standard. Not applicable to this alloy. It may be shaped by grinding but is relatively poor in regard to capability of being ground.

ASTM A600-92a-High Speed Steel

See “Heat Treatment” and “Tempering”. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Primarily used for cutting tools.

Distributors will offer small quantity buys while mills will generally only a6000 large quantities, with delivery times anywhere from 10 to 50 weeks depending on size and form required This material is stocked primarily in Bar Products by 28 distributors but is also available to a lesser extent in Flat Rolled Products, Wire Products, and Shapes. Referenced Documents purchase separately Xstm documents listed below are referenced within the subject standard but are not provided as part of the standard.